Technical specification

Copyright ©

2023-10-16

Abstract

Technical specification - scope

These technical specifications include:

Control electronics - circuit board.

Power supply - power supply.

Cabinet - enclosure.

Backup power - batteries (not included).

Technical specification - limitations

Technical specifications do not include:

Cabling - internal and external.

Circuit boards - Technical data

SDS-LAMP2

Table 1. Technical data

Max current charger:	1,5 A
Max current lamps:	9 A (18 A with four lamps).
Lighting:	1-10 LED lamps of max. 100 W per channel.
Deep Discharge Protection:	Yes, when the battery voltage drops below 9.5 V.
Alarm:	All alarms occur on potential-free relay switching.
Alarm types:	1.. Total alarm for incorrect charging voltage / aged battery. 2. Power failure.
Alarm for PSU overvoltage at:	14.2 V (one battery) or 28.4 V (two batteries).
Alarm for PSU undervoltage at:	13 V (one battery) or 26 V (two batteries).
Charger failure alarm:	The alarm is given if the power supply unit delivers undervoltage even though the batteries have been charged for more than 48 hours. The alarm is reset if the unit has charged the batteries for at least 30 seconds and the voltage from the power supply exceeds the PSU undervoltage limit.
Battery fuse:	30 A

Power supply

Power supply - Technical Data LRS-75-12

In:

Output voltage	13.6 V
Output voltage, ripple	120 mVp-p
Overvoltage	13.8 V - 16.2 V
Voltage recharge, ripple / current limitation	Less than 0.6 Vp-p
Efficiency	89%
Current limitation	110% - 150%
Constant voltage	+/- 1.0%
Regulatory accuracy	* / - 0.5%
Input current (230 V)	6 A
Mains voltage frequency	47 Hz- 63 Hz
Mains voltage	85 V AC - 264 V AC
Brand effect	72 W
Heat generation at 50% of rated power	+/- 0.03% / ° C
Heat generation at 80% of rated power	+/- 0.03% / ° C
_{The power supply is adapted and calibrated with the battery / hardware of the battery backup. Only power and calibrated power supplies may be used. Contact support when changing power supplies. Use of power supplies coming from another source may cause damage not covered by the warranty. Warranty is canceled if power supplies (from a source other than support / designated by support) that are not correctly calibrated are used.}

Technical data enclosures

Technical data Ensto 200x300x132

Technical data
Product description	Ensto Cubo O with smooth sides. On the enclosure, it is possible to mount the cover on the back of the lower part and the adjustable corner lifts allow sheets and panels to be attached at any height.
Material	ABS
Color	Gray
Protection class IP according to EN 60 529	IP 65
Dimensions	Width: 200 mm, height: 300 mm, depth: 132 mm.
Weight	1.2 kg

Batteries - recommended, not included

14 Ah, 12 V AGM battery

Fits in	Number of batteries
SDS LAMP2	2

Battery type	V	Ah
Maintenance-free AGM, lead-acid battery.	12 V	14 Ah

Table 2. 10+ Design life * battery

Article number	E-number	Article name	Terminal	Measure. Height width depth	Weight per piece	Make
MT113-12V14-01	5230537	UPLUS 12V 14Ah 10+ Design Life battery	Flat pin 6.3 mm	151x98x101 mm	4.2 kg	UPLUS

About this information

All information is published subject to possible errors. This document is updated without notice.